Viking Double Gang Entry Phone with LED

Entry Phone Features:

• Compact size: Front panel is the size of a typical double gang mid-size wall plate
• Mounting: Flush mounts in a double gang electrical box (2.25” deep x 3.7” wide x 2.84” tall minimum) or surface mounts in a Viking model VE-5x5 (not included, see DOD# 424)
• Will mount in a double gang box
• Available in 5 standard faceplate finishes: Brushed Stainless Steel, Oil Rubbed Bronze, Polished Brass, Satin Black and Satin White
• PNL-40 faceplates: Replacement faceplates with matching screws available in all five standard finishes
• Weather Resistant Features: Mylar speaker, faceplate gasket, mic and speaker gasket, internally sealed (IP67) push button switch, self draining mic mount and UV stable weather resistant powder coating (excluding E-60-SS Stainless Steel faceplate)
• Optional Enhanced Weather Protection (EWP) available
• Vandal Resistant Features: 16 gauge polished brass or 18 gauge stainless steel faceplate, stainless steel push button, stainless steel speaker screen, scratch resistant powder coating, hex drive mounting screws
• Blue LED helps locate the push button, indicate ringing and off-hook
• Telephone line powered
• Microphone and speaker volume controls
• Programmable Intelligent call progress detection for automatic hang-up on CPC, silence, busy signal, or time out
• Selectable auto answer feature for monitoring
• Programmable VOX (mic/speaker) switching speed
• Power: Telephone line powered. Minimum 18V DC talk battery voltage with a minimum loop current of 20mA. Loop current may be boosted on low current lines with a Viking model TBB-1A Talk Battery Booster (see Fax Back Document 630)
• Dimensions: Faceplate: 123.8mm x 125.4mm x 4.3mm (4.875” x 4.938” x 0.17”), Phone: 72mm x 46mm x 42mm (2.84” x 1.8” x 1.65”)
• Operating Temperature: -34° C to 65° C (-30° F to 150° F)
• Humidity: Standard model: 5% to 95% non-condensing humidity, EWP model: up to 100% humidity
• Speaker Volume: Approximately 62db maximum @ 1m
• Ring Voltage: 25V AC RMS minimum (for auto answer)
• CPC Disconnect Time: 300ms minimum
• REN: 0.8A
• Connections: (2) gel-filled butt connectors

Enhanced Weather Protection Option:

Includes weather-sealed trim pots and DIP switches, a special rubber microphone boot and a mylar speaker with a rubber gasket acting as a primary shield against water penetration. If required, face plate gaskets are provided to further eliminate water infiltration. All connections are hand soldered to eliminate corrosion, and the connections at the push button switch, microphone, and "Call Connected" LED are also hand sealed using a special non-corrosive electronics grade flexible silicone sealant. The entire circuit board is "potted" in a flexible urethane encapsulating material, leaving the weather sealed field-adjustable trim pots and DIP switches accessible for on-site programming. The flexible urethane sealant allows the circuit board and its components to expand and contract, while maintaining weather resistance. To protect the tip and ring connections, special connectors filled with anti-corrosive sealing gel are included.